Heavy-Duty Fly Mesh

Heavy-duty fly mesh steps the frame up to a 50 mm industrial profile with impact-resistant mesh, built for openings in warehouses, factories and industrial kitchens where forklifts, trolleys and material handling put real physical stress on a screen that a standard commercial unit is not built to absorb.

Best for: loading bay openings, factory floor doorways, and industrial kitchen exhaust points where accidental knocks from equipment or trolleys are a normal part of daily operations, not an occasional risk.

Built for impact, not just traffic volume: a mall entrance or hospital door (see the high-traffic page) wears from sheer cycle count; a warehouse opening more often fails from a direct knock — a trolley catching the frame, a pallet passing close. The 50 mm profile and impact-resistant mesh are sized for that specific failure mode.

Specs: industrial aluminum frame, 50 mm; reinforced fiberglass mesh; installation phased around your site’s operating schedule.

Dubai context: industrial premises here often run multiple shifts with continuous forklift and trolley movement, so screens near loading bays and material-handling routes see a different kind of wear than an office or retail door — direct impact rather than pure cycle count — which is exactly what this spec is built around.

Cold storage and refrigerated loading areas often add condensation to the mix, which is worth flagging at measurement since it affects which frame finish holds up best.

Because the frame and mesh spec here is heavier than a standard commercial screen, lead time is usually a little longer — worth building into your project timeline.

• Can this be positioned to avoid forklift routes entirely? Where possible, yes — your installer reviews the actual traffic flow during the site visit and positions the screen to minimise direct contact, though some openings inherently sit on a route.
• What happens if the frame does take a direct hit? The reinforced profile is built to absorb more than a standard frame before deforming; a damaged section is assessed and repaired or replaced individually rather than requiring a full teardown in most cases.
• Does this need a different mesh for food-related industrial kitchens? Where food-contact material rules apply, mention this at measurement — a stainless steel option is available, the same material used on the restaurant kitchen page.